Product & Accessories

DS500S MOBILELOCK Portable Alarm with GPS

Packed with wall charger and magnet for door alarm

Size: 4.4 in x 3.5 in x 1.3 in

Weight: 8.8 oz

Enclosure: UV resistent, rainproof, crush resistant to >500 lbs

Operating: -20C to +60C (-4F to 140F).  -40F to 175F in storage

Battery: Built into unit.  Runtime: approx. 30 days.  Recharge: approx. 5 hours

Mounting: Built-in magnets on back (14G holding force), screw holes with #8 clearance

 

DS505K MOBILELOCK extended runtime kit

Packed with: DS500S including wall charger and magnet, extended runtime case, 4 D cell batteries

Size: 9.0 in x 6.5 in x 2.3 in

Weight: 3 lbs 5 oz with the DS500S and batteries 

Enclosure: Rainproof, UV resistant

Battery: 4 "D" size alkaline batteries.  90 days runtime with a fully charged DS500S

Tampers: Case contains mounting tamper that alerts when it is removed from a surface and a door tamper alerts when the door is opened

Mounting: Extended runtime case does not have magnets on the back.  Four screw holes are provided for mounting

DS525 MOBILELOCK Heavy Equipment Power Supply

Packed with: clips

Connects the DS500S to any 12-24 volt (nominal) battery for permanent power

Input: Cable fused with automotive (ATC/ATO) in line fuse holder and fuse

Output: 4.65 VDC, 300mA, thermally regulated

Cables: 10 feet both directions for total mounting flexibility

Enclosure: Cast aluminum: Chemical, fuel, oil, water, rust resistant

 

DS520 Universal Sensor Input

Packed with: CR123 Lithium battery

• Easy wire up with +/- terminal block
• Accepts any normally closed sensor (N.C.)
• Multiple sensors can be wired to the unit in a closed circuit
• Provides an alarm signal to the DS500S when enabled
• Pass through port enables charging of the DS500S
• Internal tamper switch alarms when cover is removed
• The Optex BX-80NR is an indoor/outdoor motion sensor that retails around $179 and the Optex CX-702RS is an indoor motion sensor under $100.  Both can be purchased from Amazon or other dealers and can be wired into the Mobilelock using the DS520.

 

External Antenna:

In rare occassions you may need to add an external antenna to the Mobilelock to improve its cellular or GPS reception.  Antennas can be purchase from Wilson Electronics.  Click here to visit their store.

• Passive Antenna: If the Mobilelock is going into a metal box like a safe and there is sufficient signal outside of the box then you can add a passive antenna.
  • Wilson Model # 359914 is a patch with a cable connection that can velcro to the outside of the Mobilelock.  Cost from Wilson Electronics is around $3.95.
  • Wilson Model # 301113 is a 4" mini magnetic mount antenna. Cost is around $12.00. Wilson offers a variety of sizes to choose from. The patch cable connects to this and then this magnetically attached to the outside of the box.
• Powered Antenna: If there is extremely weak signal in your area but there is sufficient signal within several thousand feet then you can add a Powered External Antenna to increase the reception power for the Mobilelock. Here are some products we recommend:
  • Wilson Model # 811211 Signal Boost Mobile Amplifier
  • Wilson Model # 859903 A/C Power Supply for Mobile Amplifier
  • APC Model BE450G APC UPS (Powers the amp if a thief cuts the power prior to attempting access of the item)
  • Wilson Model # 304411 Wide band directional antenna 700-2700 MHz
  • 6 ft Pigtail adaptor to complete some of the connections